Verify correct source NAT rule is dynamically generated when the tunnel is > /ip firewall nat printįlags: X - disabled, I - invalid, D - dynamicĬhain=srcnat action=src-nat to-addresses=192.168.77.254 src-address-list=local dst-address-list=!local When it is done, we can assign newly created IP/Firewall/Address list to mode config configuration. It is also possible to specify only single hosts from which all traffic will be sent over the tunnel. First of all, we have to make a new IP/Firewall/Address list which consists of our local network. In this example, we have a local network 10.5.8.0/24 behind the router and we want all traffic from this network to be sent over the tunnel. Option 1: Sending all traffic over the tunnel In RouterOS it is possible to generate dynamic source NAT rules for mode config clients. Since the mode config address is dynamic, it is impossible to create static source NAT rule. In such case we can use source NAT to change the source address of packets to match the mode config address. But a router in most cases will need to route a specific device or network through the tunnel. If we look at the generated dynamic policies, we see that only traffic with a specific (received by mode config) source address will be sent through the tunnel. Verify that the connection is successfully established. Specify your NordVPN credentials in username and password parameters.Īdd address= exchange-mode=ike2 name=NordVPN profile=NordVPNĪdd auth-method=eap certificate="" eap-methods=eap-mschapv2 generate-policy=port-strict mode-config=NordVPN peer=NordVPN policy-template-group=NordVPN password=secret Lastly, create peer and identity configurations. While it is possible to use the default policy template for policy generation, it is better to create a new policy group and template to separate this configuration from any other IPsec configuration.Īdd dst-address=0.0.0.0/0 group=NordVPN proposal=NordVPN src-address=0.0.0.0/0 template=yesĬreate a new mode config entry with responder=no that will request configuration parameters from the server. It is advised to create a separate Phase 1 profile and Phase 2 proposal configurations to not interfere with any existing or future IPsec configuration.
Navigate to and find out the recommended server's hostname. # NAME COMMON-NAME SUBJECT-ALT-NAME FINGERPRINTĠ T r_0 NordVPN Root CA 8b5a495db498a6c2c8c. There should now be the trusted NordVPN Root CA certificate in System/Certificates > /certificate print where name~"r"įlags: K - private-key, L - crl, C - smart-card-key, A - authority, I - issued, R - revoked, E - expired, T - trusted Start off by downloading and importing the NordVPN root CA certificate. 4.2 Option 2: Accessing certain addresses over the tunnel.
4.1 Option 1: Sending all traffic over the tunnel.4 Choosing what to send over the tunnel.
0 kommentar(er)
